Toshiba SD-360ESE - Manual (Page 61)

61
Function setup
Digital Output
Selects the output sound format corresponding to your
system connection.
1) Press SETUP button.
2) Press / button to select the Audio.
3) Press button, then the / button to select
the Digital Output.
4) Press ENTER button, then the / button to
shift and change the output sound format.
5) Press ENTER button.
6) Press SETUP button to exit the menu.
PCM: Select when connected to a 2 channel digital
stereo amplifier.
The DVD video player outputs sound in the
PCM 2 channel format when you play a DVD
video disc recorded on the Dolby Digital,
MPEG1 OR MPEG2 recording system.
Raw: Disc audio raw data will be output.
Off: To disable Digital Output.
Notes
• When you make a connection to a TV, Dolby Surround
Pro Logic or stereo system via the analog audio jacks,
select “PCM” or “Raw”.
• If this DVD video player is connected to a TV using
HDMI, make sure to select “PCM”.
Night Mode
Night mode is equivalent to Dynamic Range
Compress. When it is On, it reduces the variations
between loud and soft sounds in audio output. You
can still hear softer sounds and dialogue even in
very low volume.
1) Press SETUP button.
2) Press / button to select the Audio.
3) Press button, then the / button to select
the Night Mode.
4) Press ENTER button, then the / button to
shift and change the Night Mode.
5) Press ENTER button.
6) Press SETUP button to exit the menu.
Note
Night mode is Dynamic Range Control (DRC) option
for analogue audio output.
Audio
E-54-65R.pmd 3/10/2006, 10:01 AM 61