beautypg.com

Toshiba SD-360ESE User Manual

Page 19

background image

19

Connections

Connecting to a TV (Using the component video jacks)

Interlaced outputs

Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy higher
quality picture playback.
Actual labels for component video inputs may vary depending
on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, C

B

, C

R

)

In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.

Progressive outputs

Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively scanned
video signal. Connecting to these inputs allows you to view the
highest quality pictures with less flicker.

Consumers should note that not all high definition television
sets are fully compatible with this product and may cause
artifacts to be displayed in the picture. In case of 525 or 625
progressive scan picture problems, it is recommended that
the user switch the connection to the “standard definition”
output. If there are questions regarding our TV set compatibility
with this model 525p or 625p DVD player, please contact our
Customer Service Center.

Switching the output signal (interlaced /
progressive) using the remote control

You can temporarily switch the output signal for better
picture quality.
Press PROGRESSIVE on the remote control during
stop mode.
Press PROGRESSIVE again to turn off progressive
mode.
If your TV does not support the progressive scan format,
the picture will appear scrambled or blank. To return to
normal picture, press PROGRESSIVE button again to
turn off progressive mode.

Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment from

the wall outlet before making any connections.

• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the

DVD video player away from the tuner and radio.

• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate

listening level. Otherwise, high volume sound may damage your hearing as well as the speakers.

• Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power on,

the speakers may be damaged.

• Progressive can be on/off only when “Video Output” is set to Component or P-Scan

59

.

• In component connections, the screen might become pinkish in colour when the “Video Output” is set to Composite. This is not

a defect of this unit

59

.

• When the TV system is set to NTSC mode, all output will be forced to NTSC type (eg. 525p (480p), 525i (480i), etc.)
• When the TV system is set to PAL mode, all output will be forced to PAL type (eg. 625p (576p), 625i (576i), etc.)
• Analog audio out will not have sound if DTS playback is selected.

• Make the following setting.

On-screen display

Select:

Page

“PCM” or

“Raw”

“Digital Output”

Component

*P-Scan

(Progressive)

“Video Output”

59

* Only for TV equipped with component

video input jacks which support the
progressive scan.

61

AV

Audio cable

To audio input

To Y video

input

To P

B

video

input

To P

R

video

input

To 2ch AUDIO OUT

(R: red, L:white)