Technicolor - Thomson SpeedTouch 780 (WL) - Manual (Page 47)

39 E-DOC-CTC-20051017-0153 v1.0
Chapter 4
Voice over IP
Enable the telephony
service
Proceed as follows to enable the telephony service:
1 Go to the SpeedTouch™ Web pages.
2 In the menu, select Toolbox > Telephony.
3 In the upper right corner, click Configure.
4 Select Service Enabled.
5 Click Apply.
Configure the telephony
service
Proceed as follows to configure the MGCP telephony service:
1 Go to the SpeedTouch™ Web pages.
2 In the menu, select Toolbox > Telephony.
3 In the upper right corner, click Expert configure.
4 Enter the IP address and the port number of the call agent, as provided by
your ISP.
5 Click Apply.
Verifying telephone
connectivity
Proceed as follows to verify the voice connection:
1 Make sure the SpeedTouch™ is turned on and ready for service.
2 Check whether your phone is properly attached to the SpeedTouch™.
3 Make sure the Internet telephony service is enabled and configured.
4 The VoIP Ready LED must be lit.
5 Pick up your phone, wait for the dialling tone, and dial the number. If you dial
a ‘#’ after the phone number, the phone number will be called instantly.
For more information, see “1.2.1 Access via the Web Interface” on
page 7 .
The phone(s) attached to the SpeedTouch™ can receive incoming VoIP
calls, as long as your SpeedTouch™ is turned on and the VoIP Ready LED is
lit.
For calls over the regular phone line, your phones are line powered by the
telephone company and can therefore always be reached, even if the
modem is turned off.