Technicolor - Thomson SpeedTouch 780 (WL) - Manual (Page 16)

8 E-DOC-CTC-20051017-0153 v1.0
Chapter 1
Getting to know your SpeedTouch™
1.2.2 Access via CLI
To access the
SpeedTouch™ via the
Command Line
Interface (CLI)
You can access the Command Line Interface (CLI) via:
A Telnet session
This requires a TCP/IP connection between the host from which the Telnet
session is opened and the SpeedTouch™. Your SpeedTouch™ and the
connected computer must have an IP address in the same subnet.
Quote site commands (over FTP)
For more information, see “ Quote site command” on page 12 .
For more information on CLI commands, see the SpeedTouch™ CLI Reference
Guide.