Toshiba 56HMX96 - Manual (Page 27)

27
HMX96 (E/F) Web 213:276
Chapter 4: Setting up your TV
Manually adding and deleting channels
in the channel memory
After automatically programming channels into the channel
memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T.
3
(A new set of Installation menu icons will appear on-
screen, as shown below.) Open the Terrestrial menu,
highlight Channel Add/Delete, and then press
T.
4
The illustration below left shows channels programmed
for the ANT 1 antenna input. To view the list of channels
programmed for the ANT 2 or Cable box antenna input,
press Bb to highlight ANT 2 and press
T.
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number you
want to add, and then press
T to check the box.
To manually add digital subchannels on a physical
channel:
Use the Channel Numbers and the Dash ( =) on the remote
control to enter the channel number (for example, 56–1).
If the channel is found, the number will be added to the list and
the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press
T to uncheck the box.
To save your new settings:
Highlight Done and press T.
To revert to your original settings:
Highlight Cancel and press T before saving.
To remove all channels from the channel memory:
Highlight Reset and press T, and then highlight Done and
press T.
Note: This action applies to the current antenna input only. To
delete/add channels on the other input, highlight the input you
want (ANT1, or ANT 2) and press
T.
CH RTN ENTER EXIT Navigate Select Back Exit
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Channel Add/Delete
2 Analog ANT 1
ANT 2
Reset
Cancel
Done
Digital
Digital
Analog
Analog
Analog
Analog
Analog
Digital
Analog
2 - 1
2 - 2
3
4
5
6
7
7 - 1
8
Channel Add/Delete
1 Analog ANT 1
ANT 2 Analog
Analog
Analog
Analog
Analog
Analog
Analog
Analog
Analog
2
3
4
5
6
7
8
9
10
Reset
Cancel
Done
Channel Add/Delete
2 Analog ANT 1
ANT 2
Reset
Cancel
Done
Digital
Digital
Analog
Analog
Digital
Analog
Analog
Digital
Analog
2 - 1
2 - 2
3
4
5
6
7
7 - 1
8
HMX96_EN.book Page 27 Friday, April 28, 2006 12:03 PM