Tally Genicom Tally Mono Laser T9220 - Manual (Page 83)

U SING P RINT M ATERIALS 4.20
3
When you print on transparencies, configure the paper
source, type and size properly in the software application.
For details, see page 5.7.
For details about setting on the control panel, see page 3.5.
4
After finishing, close the Multi-Purpose Tray and the rear
output tray.
N OTES :
• If you print on thin transparencies using rear output tray, they
may be curled. In this case, use the top output tray. If the
problem persists, check if your transparencies meets the
printer’s specifications.
• To prevent transparencies from sticking, do not let the printed
sheets stack up as they are printed out.
• Place transparencies on a flat surface after removing them from
the printer.