Transcend Information TS32 User Manual
Page 28
T
T
T
S
S
S
3
3
3
2
2
2
/
/
/
6
6
6
4
4
4
/
/
/
1
1
1
2
2
2
8
8
8
G
G
G
S
S
S
S
S
S
D
D
D
1
1
1
8
8
8
M
M
M
-
-
-
M
M
M
1.8” Portable Solid State Drive
Transcend Information Inc.
V1.2
28
EBh
Good Block Count, System Block Count 0
1
2
3
4
5
6
7
Good Block Count (High Byte)
Good Block Count
Good Block Count (Low Byte)
System(Free) Block Count (High
Byte)
System(Free) Block Count (Low
Byte)
Reserved
Reserved
Reserved
ECh-FFh
Reserved
SMART READ ATTRIBUTE THRESHOLD
This transfers 512 bytes of drive failure threshold data to the host.
SMART ENABLE/DISABLE ATTRIBUTE AUTOSAVE
Enables or disables the attribute value autosave function. This command specifies whether the current attribute values are
automatically saved to the drive when it changes the mode. This setting is maintained when the power is turned on and off.
SMART SAVE ATTRIBUTE VALUE
Saves any modified attribute values.
SMART EXECUTE OFF-LINE IMMEDIATE
This command of Non-data input causes the controller to immediately initiate the set of activities that collect SMART data in
a off-line mode and then save data to the Nand flash memory, or execute a selfdiagnostic test routine in either captive or
off-line mode.
SMART ENABL OPERATIONS
Enables the SMART function. This setting is maintained when the power is turned off and then back on. Once the SMART
function is enabled, subsequent SMART ENABLE OPERATIONS commands do not affect any parameters.