Transcend Information TS32 - Manual (Page 20)

T T T S S S 3 3 3 2 2 2 / / / 6 6 6 4 4 4 / / / 1 1 1 2 2 2 8 8 8 G G G S S S S S S D D D 1 1 1 8 8 8 M M M - - - M M M
1.8” Portable Solid State Drive
Transcend Information Inc.
V1.2
20
85 3029h
X
F
F
F
X
V
F
V
V
V
V
F
F
X
V
V
Command and feature sets supported or enable
15 Obsolete
14 1 = The NOP command is supported
13 1 = The READ BUFFER command is supported
12 1 = The WRITE BUFFER command is supported
11 Obsolete
10 1 = HPA feature set is supported
9 Shall be cleared to zero to indicate that the DEVICE RESET command is not supported
8 1 = The SERVICE interrupt is enabled
7 1 = The release interrupt is enabled
6 1 = Read look-ahead is enabled
5 1 = The volatile write cache is enabled
4 Shall be cleared to zero to indicate that the PACKET Command feature set is not supported.
3 Shall be set to one to indicate that the mandatory Power Management feature is supported
2 Obsolete
1 1 = The Security feature set is enabled
0 1 = The SMART feature set is enabled
86 1000h
F
F
F
F
F
V
V
F
V
X
V
F
F
F
Command and feature sets supported or enable
15 1 = Words 119-120 are valid
14 Reserved
13 1 = FLUSH CACHE EXT command supported
12 1 = FLUSH CACHE command supported
11 1 = The DCO feature set is supported
10 1 = The 48-bit Address feature set is supported
9 1 = The AAM feature set is enable
8 1 = The SET MAX security extension is enabled by SET MAX SET PASSWORD
7 Reserved for Address Offset Reserved Area Boot Method
6 1 = SET FEATURES subcommand required to spin-up after power-up
5 1 = The PUIS feature set is enabled
4 Obsolete
3 1 = The APM feature set is enabled
2 1 = The CFA feature set is supported
1 1 = The TCQ feature set is supported
0 1 = The DOWNLOAD MICROCODE command is supported
87 4000h
F
F
F
X
F
F
F
F
X
V
V
F
F
Command and feature sets supported or enabled
15 Shall be cleared to zero
14 Shall be set to one
13 1 = The IDLE IMMEDIATE command with UNLOAD feature is supported
12-11 Reserved for TLC
10-9 Obsolete
8 1 = The 64-bit World wide name is supported
7 1 = The WRITE DMA QUEUED FUA EXT command is supported
6 1 = The WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands are supported
5 1 = The GPL feature set is supported
4 Obsolete
3 1 = The Media Card Pass Through Command feature set is supported
2 1 = Media serial number is supported
1 1 = SMART self-test supported
0 1 = SMART error logging supported