Telenetics 2185 - Manual (Page 26)

Telenetics 2185
3-4
Switch segments 1-6 to 1-8 are used to set the data rate on the 2185. See
Table 3-2 for information on setting these switches.
Function Switch Two
Function switch two is an eight-segment DIP switch used to set control-
signal contention, select synchronous or asynchronous data format,
select or bypass the retiming buffer, enable or disable anti-streaming, set
the clock signal routing, set main channel RTS on DCD transparent or
on, and set main channel inbound CTS transparent or on.
Table 3-2. Data Rate Selection
Using Switch Segments 1-6 to 1-8
Clock Data
Rate (bps) Set 1-6 to: Set 1-7 to: Set 1-8 to:
75 Up Up Up
1200 Up Up Down
2400 Up Down Up
4800 Up Down Down
7200 Down Up Up
9600 Down Up Down
14400 Down Down Up
19200 Down Down Down
Table 3-3. Function Switch Two Summary
Function
Switch
Switch
Position Function
2-1 Up
Down Sets Control Signal Contention
Sets Data Contention
2-2 Up
Down Sets synchronous data format
Sets asynchronous data format
2-3 Up
Down Synchronous Data Retiming Buffer in circuit
Synchronous Data Retiming Buffer bypassed
2-4 Up
Down Disables Anti-Streaming
Enables Anti-Streaming
2-5 and 2-6 See Table 3-4 These two switches work together to set Clock
Routing