Technicolor - Thomson 42WM03STW-0707 - Manual (Page 8)

8
EN
100 ~ 240 V 50/60 Hz
Switching on
Follow the instructions on this page to switch on the TV set and the remote control.
+ - 2
+
+
-
1 3
Please respect the environment and the
relevant regulations. Before you dispose of
batteries or accumulators, ask your dealer
whether they require special recycling and if he
is able to take them back.
13A
Main socket in
continental Europe
1 Install two LR06 or AA batteries in the remote control.
Precautions on using batteries:
– Only use the battery types specified.
– Make sure you use the correct polarity.
– Do not mix new and used batteries.
– Do not use rechargeable batteries.
– Do not expose batteries to excessive heat, throw them on the
fire, recharge them or try to open them, as this could cause
them to leak or explode.
– Remove the batteries from the remote control if you are not
using it for a long period of time (several weeks).
2 Connect the TV set to a mains socket.
The set should only be connected to an AC supply.
It must not be connected to a DC supply. If the plug is detached
from the cord, do not, under any circumstances, connect it to a
mains socket, as there is a risk of electric shock.
Equipment for the UK is supplied with a mains cable fitted with a
moulded plug. This plug contains safety components and must
not be replaced by one sold by general retailers. It is fitted with a
fuse that protects your television. If your set has stopped
working, the fuse may have blown. If it has, replace it with an
identical ASTA or BSI certified (BSI 362) 13-amp fuse.
3 Connect the outside aerial or cable network to the antenna
connector (labelled ANT) on the rear panel of the monitor.
The aerial socket can be used for connecting an external aerial or
other equipment fitted with a modulator (video recorder, satellite
receiver, etc.).
We recommend that you do not connect other equipment (video
recorder, satellite receiver, etc.) to your TV set to begin with, so
as not to complicate the set-up procedure with this additional
equipment. Connect them when you have finished setting up the
channels.
4 Switch the TV set on by putting the main power switch located at
the back on the ON position, then pressing the power button on
the front panel.
The first time you switch on the TV set, the language selection
menu appears.
42WM03STW-0707-en.p65 2003/9/5, PM 12:53 8