Toshiba IK-TF2 - Manual (Page 30)

- 30 -
Symptom Items to be checked
No image
ჷ Is the power supplied correctly?
ჷ Is the lens iris adjusted correctly?
ჷ Are the cables connected correctly?
ჷ Is the shutter mode set correctly?
Poor color
ჷ Is the monitor (TV) adjusted correctly?
Is the white balance of the camera adjusted correctly?
ჷ Is the illumination dark?
Power supply
DC12V 10%
Power consumption Approx. 3.6W
Pick-up system RGB, 3CCD, Micro prism system
Image sensor 1/3inch IT
*CCD
(Effective pixels) *Horizontal*768pixels, Vertical*494pixels*
Scanning system 2
*1 interlace
Scan frequency Horizontal
*15.734kHz, Vertical*59.94Hz
Sync system Internal/External(Automatic switching)
Horizontal resolution 570TV lines
Sensitivity F8 standard
*2000 lx, 3000K*
Minimum illumination 10 lx
*F2.2, Sensitivity*18dB, 3000K*
SN ratio 64dB standard (G)
Lens mount C mount(flange back *17.526mm in-air)
Ambient temperature 32 to 104 F (0 to 40 )
Ambient humidity Less than 90%
Weight Approx. 5.47oz (155g)
External dimension
1.73”(W) 1.73”(H) 3.07”(D)
(44(W) 44(H) 78(D)mm) (except for protruded portion)
White balance AWB
*Automatic white balance*, MANUAL*Manual*
Gain MANUAL *Manual*, OFF*0dB*
Output signal RGB
*
75 unbalanced, D sub 15 pin connector
External sync input HD or VD
* 2*5V(p*p) Negative
Sync signal output SYNC
*
HD, VD, INDEX
*
2.0V 1V(p
*p) 75 unbalanced
5V V(p
*p) , Negative,
Load impedance
*More than 10k
External trigger input TRIGGER * Low level *Less than 0.4V, High level*3.4*5V
1 Pulse
* Positive/Negative/Width selectable
2 Pulse
* Positive/Negative/Width selectable
Interface Serial data interface
*RS-232C*
Optional parts EXC
*TF05B(RGB cable), etc
ʜDesign and specifications are subject to change without notice.
+0.5
-1.0
9 SPECIFICATIONS
8 BEFORE MAKING A SERVICE CALL