Restoring the pre-installed software, Creating optical recovery discs – Toshiba SATELLITE A660D User Manual
Page 33
User’s Manual
1-13
Satellite A660/A660D, Satellite A665/A665D
Restoring the pre-installed Software
Depending on the model you purchased, different ways for restoring the
pre-installed software are offered:
■
Creating optical Recovery Discs and restoring the pre-installed software
from them
■
Restoring the pre-installed software from the Recovery hard disk drive
■
Ordering Recovery Discs from TOSHIBA and restoring the pre-installed
software from them*
* Please note that this service is not free-of-charge.
Creating Optical Recovery Discs
This section describes how to create Recovery Discs.
A recovery image of the software on your computer is stored on the hard
disk drive, and can be copied to DVD media by using the following steps:
1. Have a blank DVD media ready.
2. The application will allow you to choose from a variety of different media
onto which the recovery image can be copied including DVD-R, DVD-R
DL, DVD-RW, DVD+R, DVD+R DL and DVD+RW.
3. Turn on your computer and allow it to load the Windows 7 operating
system from the hard disk drive as normal.
4. Insert the first blank media into the optical disc drive tray.
■
Be sure to connect the AC adaptor when you create Recovery Discs.
■
Be sure to close all other software programs except the TOSHIBA
Recovery Media Creator.
■
Do not run software such as screen savers which can put a heavy load
on the CPU.
■
Operate the computer at full power.
■
Do not use power-saving features.
■
Do not write to the disc when the anti-virus software is running. Wait
for it to finish, then disable virus detection programs including any
software that checks files automatically in the background.
■
Do not use utilities, including those intended to enhance hard disk
drive access speed. They may cause unstable operation and damage
data.
■
Do not shut down/log off or Sleep/Hibernate while writing or rewriting
the disc.
■
Set the computer on a level surface and avoid places subjected to
vibrations such as airplanes, trains, or cars.
■
Do not use on unstable tables or other any other unstable surfaces.
Please note that some of the above media may not be compatible with the
optical disc drive installed into your computer. You should therefore verify
the optical disc drive supports the blank media you have chosen before
proceeding.