Toshiba PDR-T20 - Manual (Page 54)

54
Getting Ready
Playing Back/Deleting Photographed Images
Connecting to the
PC
Other Useful
Information
T
aking Photographs
Connecting to a Macintosh
The Macintosh must have Mac OS 9.0 or later installed. Because this camera supports
the USB Mass Storage Class, a Macintosh with Mac OS 9.0 or later does not require the
installation of the USB driver.
Insert the supplied CD-ROM into the CD-ROM drive.
The language selection window appears.
Click the [ ] icon.
Click the [ ] icon.
Setting up is started.
Follow the shown instructions to install
ACDSee
TM .
When the installation is completed, the
ACDSee
TM icon appears on the desktop.
Connect the USB cable to the PC and this camera.
Connect one end of the USB cable to the USB port
on the PC, and the other end to the DIGITAL terminal
on this camera.
When connecting the USB cable, be careful with that
the PUSH mark on the cable plug faces toward the
touch panel.
Notes
• When the camera is connected with the USB cable, it is displayed as an “untitled” disk on
the desktop and automatically enters the PC mode.
• With the USB driver installed, simply reconnecting the USB cable causes the PC to
automatically identify this camera so that images can be transferred.
• To connect the USB cable smoothly and properly, pay attention to the shapes of the
connectors on the cable.
• When in connection with the PC, Auto Power Off does not operate.
• When another USB drive is used at the same time, the SD card in this camera may not be
mounted on the desktop. If this happens, connect only this camera to the PC.
DIG ITAL