beautypg.com

About battery wear, Using the battery efficiently, Battery wear – Toshiba PDR-T20 User Manual

Page 21

background image

21

èÄîıÇ

ÇÈ

Getting Ready

Playing Back/Deleting

Photographed Images

Connecting to the

PC

Other Useful

Information

T

aking Photographs

Notes

• Charge the battery when using this camera for the first time. To charge the battery, load

them in the battery compartment of this camera. It takes approximately 4 hours to
complete charging.

• When loading the battery after incorrectly terminating the camera, the camera may not be

correctly initiated. If this happens, turn the power off, then turn it on again.

• The battery must be charged when the ambient temperature is in the range from +50

°F

(+10

°C) to +86°F (+30°C).

Battery Wear

When the power is turned on, the camera shows the remaining battery power on the
LCD monitor.

About battery wear

The battery wear may vary depending on length of storage since manufacture of the
battery, temperature of the camera and battery, and operating condition such as flash.
Moreover, if the polarities of the battery (+ or –) and the terminal of the camera that come in
contact with the electrodes are contaminated, electricity will not flow properly and the
camera will decide that the battery are exhausted. When removing and loading the battery,
be careful not to tap these parts. If the parts are contaminated, clean with a dry cloth.
When using the supplied Lithium-ion battery pack, the number of photographs that can be
taken are shown as below.

Conditions: +77

°F (+25°C), Flash use rate 100%

Photography interval: 1 frame every 30 seconds
Possible number of shots: 120 shots
* The number of frames shown above is a reference value.

Using the battery efficiently

• This camera consumes electricity even with the power off while the amount is extremely

small. We therefore recommend that the battery be removed when not using the camera
for a long period of time. If the camera is left without battery about a week, the date, time
and other settings may be reset to the factory defaults. If this happens, set the correct date
and time again before using the camera.

• When using the camera in cold areas, keep the camera and battery warm by holding them

inside your outer cloth.
Battery performance lowered through low temperature will return to normal when a normal
temperature is restored (+77

°F (+25°C)).

Meaning

Sufficient amount left

Fairly consumed

Nearly exhausted

Completely exhausted

Display