Step 7, Programming, go to, Step 9 – Toshiba STRATA CIX DKT User Manual
Page 105
IPT2010-SDC
IPT2010-SDC Programming
Strata CIX and CTX IPT/DKT Telephone 08/07
87
4. Press FB04 – Flash timing (100 ms units) (Hook Flash to the CO timing is +/- 10
ms). Press Hold. Go to the next Step or, if you are finished programming, go to
. Flash is used to answer Call Waiting and access Centrex features and
should normally be set to default.
1 ~ 20 (Default: 6 (600 ms))
5. Press FB05 – ACO Pad - This affects only the CO Line pad level. This is the same
function as the pad jumper on the CO Line card. The IPT pad levels are set by the
CIX system PAD Table programming. Press Hold. Go to the next Step or, if you
are finished programming, go to
.
2 = 3 dB pad. Set 3dB if the local CO is very close to your telephone connection
causing the audio volume level to be too high.
1 = No pad (Default)
Note
During installation, leave ACO Transmit and Receive levels (FB20 and FB19)
at default. Use FB05 to adjust ACO level. If additional adjustment is needed,
then use FB20 and FB19.
6. Press FB06 – Country Code, set to 0 for United States and Canada. Press Hold.
Go to the next Step or, if you are finished programming, go to
.
7. Press FB07 – Auto Hold ACO line (No Auto Hold releases the ACO line). Press
Hold. Go to the next Step or, if you are finished programming, go to
2 = Auto Hold
1 = No auto hold
8. Press FB08 – LCD Language for ACO. Select the display language then, press
Hold.
1 = US English 3 = British English
2 = French 4 = Spanish
9. Press Hold again to save the changes.
10.Lift, then replace hand set to exit programming mode.
FB09 ~ FB20 - Do not change.