TRENDnet TEG-S4000I - Manual (Page 19)

4.
Connecting to the Network
This chapter provides the installation procedure and instructions for
assigning IP address. This chapter contains following topics:
Pre-instruction requirements
Mounting the switch
Connecting to the switch
Assigning IP address
Pre-Installation Requirements
Before you start hardware installation, make sure your installation
environment has below items:
PCs with 10/100/1000Mbps Ethernet cards: Your PC must
have a standard Ethernet interface to connect to the switch.
UTP cable with RJ-45 connector: Check if the cable and
connectors work properly.
Fiber cable with SC/ST/MT-RJ/VF-45 connector: Check if the
cable and connector types are correct.
A power outlet: 100 to 240V AC at 50 to 60 Hz. Make sure that
the switch power is accessible and cables can be connected
easily.
Dedicated power supply: Use dedicated power circuits or
power conditioners to supply reliable electrical power to the
network devices.
A dry cool place: Keep the switch away from moisture. Avoid
direct sunlight, heat source, and high amount of electromagnetic
interference around.
Mounting tools: If you intend to mount the switch on a rack,
make sure you have all the tools, mounting brackets, screws.
19