TOA Electronics D-901 - Manual (Page 50)

50
[Q settings]
[ O U T 1 ] F I L T E R 1
Q 0 . 2 6 7
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the Q.
Parameter setting range: 0.267 – 69.249 (96 points)
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
[Center frequency settings]
[ O U T 1 ] F I L T E R 1
F R E Q 1 . 0 0 k H z
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the center frequency.
Parameter setting range: 20 Hz – 20 kHz in 1/24 octave steps
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
9.5. Compressor Settings
ON When any of the following screens is displayed, the compression function for the displayed channel
can be enabled or disabled with the function ON/OFF key. When enabled (ON), the function
ON/OFF Indicator lights.
[Screen display operations]
Filter settings (P. 45)
Delay time settings (next page)
Ratio Threshold level Attack time Release time Makeup gain
[ O U T 1 ] C OM P
T H R E S H + 0 d B
[ O U T 1 ] C OM P
R A T I O 1 : 1
[ O U T 1 ] C OM P
G A I N + 0 d B
[ O U T 1 ] C OM P
A T T A C K 1 0 . 0 m s
[ O U T 1 ] C OM P
R E L E A S E 5 0 0 m s
9.5.1. Threshold level settings
[ O U T 1 ] C O M P
T H R E S H + 0 d B
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the threshold level.
Parameter setting range: –20 to +20 dB in 1 dB steps
• Pressing an Output channel selector key permits the compressor
threshold level to be set for that channel. The [OUT 1] indication
changes to the selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
9.5.2. Ratio settings
[ O U T 1 ] C O M P
R A T I O 1 : 1
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the ratio.
Parameter setting range: 1:1, 2:1, 3:1, 4:1, 8:1, 12:1, 20:1, INF
(
∞):1
• Pressing an Output channel selector key permits the
compression ratio to be set for that channel. The [OUT 1]
indication changes to the selected channel number indication.