Toshiba E-STUDIO 755 - Manual (Page 37)

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Staple Jam 35
1 TROUBLESHOOTING FOR THE HARDWARE
11 Make sure of the following two requirements before test stapling:
y The Saddle Stitch Finisher is securely attached to the equipment.
y A3, B4, A4-R, LD, or LT-R paper is set in the drawer.
6 Remove the jammed staples.
Do not touch the stapling area (A in the figure).
The actual needle point could cause you personal injury.
7 Push the knob (2) to return it to its original position.
Make sure that the lever (1) is latched on the shutter.
8 Fit the staple cartridges.
Push down each cartridge until it is fixed with a click.
9 Unlock the stapler by pulling its handle toward you.
Then return the stapler to its original position.
10 Carefully insert the saddle stitch unit into the finisher.
A
1 2
1
2