Toshiba E-STUDIO 755 - Manual (Page 19)

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Jam 17
1 TROUBLESHOOTING FOR THE HARDWARE
„ Paper jam in the Finisher, Hole Punch Unit and Inserter (all optional)
4 Close the Hole Punch Unit cover.
5 Close the feeder tray and connect the External Large
Capacity Feeder to the equipment.
Slowly move the External Large Capacity Feeder placing your hands
on the positions shown in the figure.
1 Separate the finisher from the equipment.
Separate the finisher from the equipment while pressing the lock lever.
Place your hand on portion A in the figure and then move the finisher
carefully.
2 When the Hole Punch Unit is installed, open the Hole
Punch Unit cover.
3 Turn the green knob until the triangle mark ( ) falls
within the designated area of the label.
5 Remove paper that sticks out from the paper feeding
side.
A