Toshiba DLP 52HM95 - Manual (Page 81)

81
Chapter 8: Using the TV’s features
(E) 46/52/62HM95
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Adjusting the picture
(continued)
Using MPEG noise reduction
The MPEG noise reduction feature allows you to reduce
visible interference caused by MPEG compression. Choices
for MPEG noise reduction are High, Medium, Low and Off.
Off is automatically selected when this feature is disabled
(“grayed out”).
To select the MPEG noise reduction level:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
3. Press
z to highlight the MPEG Noise Reduction field, and
then press x or • to make a selection.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
Done
Lamp Mode Low Power
Reset
MPEG Noise Reduction Low
Dynamic Contrast On
Color Temperature Cool
Auto
ANT 1 Advanced Picture Settings
CableClear
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Using dynamic contrast
When dynamic contrast is set to “On,” the TV will detect
changes in the picture quality that affect the appearance of your
contrast settings and automatically adjust the video.
When dynamic contrast is set to “Off,” the settings selected in
the Contrast field in Picture Settings will be used.
To select dynamic contrast preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
3. Press
z to highlight the Dynamic Contrast field, and then
press x or • to select either On or Off.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
Done
Lamp Mode Low Power
Reset
Low
Dynamic Contrast On
Color Temperature Cool
Auto
ANT 1 Advanced Picture Settings
CableClear
MPEG Noise Reduction Low
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note:
If you select one of the factory-set picture modes (Sports,
Standard, or Movie) and then set the dynamic contrast to “On,”
the picture mode automatically changes to Preference in the
Picture Settings menu.
HM95_R2_079-86_061505 6/27/05, 5:11 PM 81