Toshiba TDP-S9 - Manual (Page 22)

22
Note
• The start-up screen will disappear after a moment.
■ Turning the power off
1
Press the I/ ON/STANDBY button.
A message appears on the screen, confirming that you wish to shut off the power. This
message will disappear after a moment. (This operation is no longer valid after the
message disappears.)
2 Press the I/ ON/STANDBY button again.
The screen turns off, but the internal cooling fan continues to operate for a short while.
Then, the projector goes into standby mode.
When cooling lamp During internal cooling After cooling complete
A
During cooling, the LAMP indicator flashes. In this state, the power cannot be
turned back on.
B
After the LAMP indicator goes off, the cooling fan continues to operate for a
short while, in order to expel excess internal heat. If you are in a hurry, there is
no problem with unplugging the power cord or turning off the main power switch
in this state.
C
In standby mode
Note
• The projector consumes about 6W of power in standby. We recommend that you unplug the power
cord or turn off the main power switch if you will not be using the projector for an extended period.
PRECAUTION
• If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to
cool before plugging it back in. If the lamp overheats, it may fail to light, and its lifetime will be
shortened.
A
(Green)
Flashing
(Green)
B
(Green)
C
(Green)
Flashing