Toshiba TDP-S9 - Manual (Page 19)

19
Preparations
Floor-mounted front projection Floor-mounted rear projection
Ceiling-mounted front projection Ceiling-mounted rear projection
Projection Distance and Size
Use the figures, tables, and formulas below to determine the projection size and projection distance.
(Projection sizes are approximate values for full-size picture with no keystone adjustment.)
Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is “floor-mounted front projection.” Set the projection type in the
Advanced menu
p.32
, in accordance with your needs.
WARNING
• Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit.
Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus
resulting in injury.
• If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the
projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge.
Improper mounting could cause the projector to fall, resulting in an accident.
• If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let
everyone involved with the use of the projector know that fact.
a is the distance (m) between the lens and the
screen, and corresponds to a range of 1.20 m to
10.00 m. H is the height from the image bottom to the
center of the lens.
projection
projection distance a (m)
height (H)
min length max length
size (inches)
(zooming max) (zooming min)
(cm)
27.5
40
50
60
80
100
150
200
229
275
-
1.5
1.8
2.2
2.9
3.6
5.5
7.3
8.3
10.0
1.2
1.7
2.2
2.6
3.5
4.4
6.5
8.7
10.0
-
5.9
8.5
10.7
12.8
17.1
21.3
32.0
42.7
48.9
58.7
Placement
a (min length) = projection size (inches) x 0.03636
a (max length) = projection size (inches) x 0.04363
H
a
90 °
Screen As seen from above
Lens center
As seen from the side
90 °
Lamp
On