Toshiba SATELLITE A200 - Manual (Page 183)

4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-65
Installing the VGA Board
To install the VGA board, follow the steps below and refer to the figure in the preceding
section:
CAUTION: If you remove the heat sink, use the grease tool to remove the grease on the
VGA board and heat sink. Reapply fresh grease before installing the heat sink.
1. Place the VGA board in the chassis and secure with four M2.5x4 screws.
2. Place the VGA heat sink on top of the VGA board.
3. Screw the four spring screws to secure the VGA heat sink to the VGA board. Follow the
order indicated by the numbers on the heat sink to remove the screws.