Toshiba SATELLITE A200 - Manual (Page 123)

4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-5
Disassembly Procedures
The computer has two basic types of cable connectors:
‰
Pressure Plate Connectors
‰
Standard Pin Connectors
To disconnect a Pressure Plate connector, lift up the tabs on either side of the connector’s
plastic pressure plate and slide the cable out of the connector. To connect the cable to a
Pressure Plate connector, make sure the pressure plate is fully lifted and slide the cable into
the connector. Secure the cable in place by pushing the sides of the pressure plate down so the
plate is flush with the sides of the connector. Gently pull on the cable to make sure the cable
is secure. If you pull out the connector, connect it again making sure the connector’s pressure
plate is fully lifted when you insert the cable.
Standard pin connectors are used with all other cables. These connectors can be connected
and disconnected by simply pulling them apart or pushing them together.
Assembly Procedures
After you have disassembled the computer and fixed or repaired the problem that was causing
the computer to operate abnormally, you will need to reassemble the computer.
Install all the removed FRUs following the steps described in the corresponding sections in
this chapter.
While assembling the computer, remember the following general points:
‰
Take your time, making sure you follow the instructions closely. Most problems
arise when you assemble the computer in a hurry.
‰
Make sure all cables and connectors are securely fastened.
‰
Before securing the FRU or other parts, make sure that no cables are pinched by
screws or the FRUs.
‰
Check that all latches are closed securely.
‰
Make sure all the correct screws are used to secure all FRUs. Using the wrong
screw can either damage the threads on the screw or the head of the screw, and
may prevent proper seating of an FRU.
After installing an FRU in the computer, confirm that the FRU and the computer are
functioning properly.