Toshiba SATELLITE A200 - Manual (Page 145)

4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-27
7. Lift and remove the keyboard.
Figure 4-27 Removing the keyboard
Installing the Keyboard
To install the keyboard, follow the steps below and refer to the figures in the preceding
section.
1. Connect the keyboard cable to the system board.
2. Clip the keyboard back into its fitting.
3. Place the keyboard on the top cover, insert under the center tab, and secure it with two
black M2.5x2.5 screws.
4. Set the strip cover and press down to secure the strip cover until the latches engage.