Tyan Computer TIGER MP S2460 - Manual (Page 37)

Tiger MP S2460 37
(advanced setup, continued)
3F8, 2F8
3E8, 2E8 These options are depen-
dent on the IRQ, and vice
versa.
FORMAT: [option]
OPTIONS:
Base I/O
NOTES: Recommended combinations include ‘3F8,
IRQ4’ and ‘2F8, IRQ3’.
IRQ4
IRQ3 These IRQs are paired
with the Base I/O option.
FORMAT: [option]
OPTIONS:
Interrupt
NOTES: Recommended combinations include ‘3F8,
IRQ4’ and ‘2F8, IRQ3’.
Normal Selects the mode to use.
FORMAT: [option]
OPTIONS:
Mode
NOTES: This option is only for Serial Port B.
FORMAT: [option]
OPTIONS:
Parallel Port
Disabled ‘Disabled’ turns off the
port.
Enabled ‘Enabled’ requires you to
enter the base I/O
address and the INT num-
ber.
Auto ‘Auto’ makes the BIOS
configure the port during
POST.
Output only Standard one-way proto-
col for parallel devices.
FORMAT: [option]
OPTIONS:
Mode
Bi-directional Two-way protocol for par-
allel devices.
EPP Enhanced Parallel Port
interface may provide
higher bandwidth, if an
EPP device is used.
ECP Enhanced Capability Port
interface may provide
higher bandwidth, if an
ECP device is used.
378
278
3BC These options appear
when the parallel port is
set to ‘Enabled’.
FORMAT: [option]
OPTIONS:
Base I/O
IRQ5
IRQ7 These options appear
when the parallel port is
set to ‘Enabled’.
FORMAT: [option]
OPTIONS:
Interrupt