Erasing images – Olympus E-P2 User Manual
Page 88

88
EN
5
Pl
ayback
f
u
nct
ions
Protecting selected frames
During index display you can select multiple images and protect them all at the same time.
1
During index display, select the images you want to protect using
k, then press
the
i button.
• The selected images will be shown with v.
• To cancel your selection, press the
i button again.
2
Press
k to select the next images you want to protect, then press the i button.
3
After you have selected the images to protect, press the
0 button.
Canceling all protections
This function lets you cancel the protection of several images at one time.
1
MENU[q][RESET PROTECT]
2
Use
fg to select [YES], then press the i button.
x
Notes
• Formatting the card erases all images even if they have been protected.
g“Formatting the card” (P. 127)
• Protected images cannot be rotated even when the F button is pressed.
Lets you erase recorded images. You can select single-frame erase, which erases only the
currently displayed image; all-frame erase, which erases all the images stored on the card; or
selected frame erase, which erases only the frames selected.
x
Notes
• When you perform all-frame or selected frame erase on images recorded using RAW+JPEG,
both the RAW and JPEG images are erased. When using single-frame erase, you can select
whether to erase the JPEG, RAW, or both RAW and JPEG images.
g“RAW+JPEG
ERASE” (P. 106)
• Protected images cannot be erased. Cancel protected images, then erase them.
• You cannot restore images which have been erased. Be careful not to erase important data.
g“Protecting images” (P. 87)
Erasing images
s0026_e_00_0_unified.book Page 88 Tuesday, September 29, 2009 10:30 AM