One for All (URC-8910) - Manual (Page 54)

KEY INDEX
Audio Amplifier Functions
Press RCVR/AMP once to control your audio
amplifier.
Press POWER once to turn on or off the
selected device (e.g, RCVR/AMP).
Use GUIDE to display your audio amplifier’s
program guide or setup menu.
Use INFO to display the audio amplifier’s
program information.
Use SELECT to set the surround sound. Use ▲
(or ▼ ) to adjust the volume higher (or lower).
Use (or ) to adjust the balance left (or
right).
Use VOL+ (or VOL-) to raise (or lower) the
audio amplifier’s audio volume.
Press MUTE once to turn the audio amplifier’s
audio off or on.
Use CH+ (or CH-) to select the audio amplifier’s
next higher (or lower) station (if applicable).
Use PREV to change the radio band
(if applicable).
Use the keypad (1 ~ 9 and 0) to
select audio sources (e.g., 1~ 10). If
the original remote control required
pressing an Enter key to change the
audio source, also press the ENTER
key after the source number (e.g.,
9 -ENTER).
Press ENTER once after entering the source
numbers on some audio amplifiers.
Use TV/VID to switch the audio amplifier
between input and output.
▲
▲
SELECT
SU
RRO
UND SOUND