One for All (URC-8910) - Manual (Page 11)

For example, to enter the first GE VCR code (on
page 17), press 0 twice, 6 once, 0 once, and then
SELECT once.
If the code is entered correctly, you will see the
[SUCCESS] message.
6. Press EXIT to exit the programming mode.You will
see an [EXIT SETUP] message as the URC-8910
remote control returns to normal operation.
7. To verify the code works, aim the URC-8910 remote
control at the desired device, press its device key
once and then press POWER once. The device should
turn off. If it does not respond, repeat steps 2
through 6, trying each code for your brand until you
find one that works. If it still does not work, try
Searching For Your Code on page 27.
NOTE: If the device does not have a POWER key, press the
(Play) key.
8. Repeat steps 1 through 7 for each device you want
to control. For future reference, write down each
working device code in the boxes below:
TV Code:
VCR Code:
DVD Code:
SAT Code:
CBL Code:
RCVR/AMP
Code:
CD Code:
AUX Code:
Aux. Device
Type:________________________________
11