One for All (URC-8910) - Manual (Page 39)

NOTE: If you go past [KEYMOVER], press the ▲ key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to [FROM MODE].
4. Select a source mode (e.g., TV) and press it once.You
will see the display change to [FROM KEY].
5. Select a source key (e.g., VOL+) and press it once.
You will see the display change to [TO MODE].
6. Select a destination mode (e.g., VCR) and press it
once.You will see the display change to [TO KEY].
7. Select a destination key (e.g., VOL+) and press it
once.You will see the display change to [SUCCESS],
followed by [EXIT SETUP]. The URC-8910 remote
control will automatically exit the programming
mode and return to normal operation.
8. Repeat steps 1 through 7 twice more, substituting
VOL– and MUTE as source and destination keys in
steps 5 and 7.
Upon completion of the above procedure, you can now use your
URC-8910 remote control to control the TV’s volume and mute in
the VCR mode, as well as in the TV mode.
Restoring Keymoved Keys to Default Settings
Restoring A Single Keymoved Key
1. Perform steps 1 through 7 of the previous section,
Programming Keymover on the previous page.
However, this time in step 6, make the destination
mode the same as the source mode (e.g., TV).You
will see the display change to [CLR KMVR].
continued on next page...