One for All CINEMA 7+ URC 7800 - Manual (Page 3)

Web Site : http://www.oneforall.com
5
Web Site : http://www.oneforall.com
4
FEATURES AND FUNCTIONS
The illustration below and the chart on the next three pages
describe the features and functions of the Cinema 7+™ uni-
versal remote control. Use the drawing to locate each feature
of the remote, then refer to the chart for a description of what
function each feature performs.
FEATURE - FUNCTION
The Light (LED) flashes red to show
that the remote is working and is sending a signal.
The SETUP key is used to program your
Cinema 7+™.
The POWER key controls power ON and OFF the
same as the POWER key on your original remote.
Please note that most CD Players do not have an
ON/OFF function on the original remote control. If
this is the case with your CD Player, then POWER
will have no effect on your CD Player.
The TV, VCR, DVD/LD, RCVR, AUX, CD and
CBL/SAT keys are used to select the home enter-
tainment component you want to control. If your
component does not respond when you press a key
on the remote control, press the appropriate device
key (TV, VCR, DVD/LD, RCVR, AUX, CD or CBL/
SAT) first to tell the remote control which component
you would like the remote to operate.
The VOL (Volume Up), VOL (Volume Down) and
MUTE keys control the volume the same as the
Volume Up and Down and Mute keys on your
original remote.
The CH (Channel Up) and CH (Channel Down)
keys change channels the same as the Channel Up
and Down keys on your original remote. The
CH
/ keys also control the following functions in
other modes: DVD/LD mode = Skip Forward/ Skip
Reverse, RCVR, AUX and CD mode = Preset
Up/Preset Down.
The Digit keys (0-9) control direct channel access
the same as the Digit keys on your original remote.
The Digit keys (0-9) may also control the following
functions in other modes: RCVR and AUX modes =
Input Selections.
The ENTER key operates the same as the Enter key
on your original remote. If your original remote con-
trol required you to use an Enter key to change
channels, use the ENTER key on the Cinema 7+™
after entering your channel number. The ENTER key
may also control the following functions in other
modes: RCVR and AUX modes = TAPE MON.
The PREV CH (Previous Channel) key operates the
same as the Last Channel or Recall key on your
original remote. The PREV CH key may also control
the following functions in other modes: DVD/LD,
RCVR, AUX and CD mode = Random.