beautypg.com

Onkyo DR-C500 User Manual

Page 65

background image

65

This unit contains a sensitive microcomputer, which under certain circumstances might fail to operate due to excessive noise
interference. If this happens, in Standby mode, press

¢, 4, 7 in order on the unit. All the custom settings for the receiver

section of the DVD Changer Receiver will be erased. Please repeat the custom settings from the beginning.

Causes

• FM stereo waves may produce a hiss

noise when a certain level is reached.

• The position or direction of the FM

antenna is incorrect.

• The station is too weak.

• The radio wave is distorted.
• Cars are running or airplanes are flying

near the house.

• There is a tall building or a mountain

nearby.
(The waves transmitted from the
transmission center (direct waves) and
the waved reflected by buildings or
mountains (diffraction waves) interfere
with each other causing multi pass
distortion.)

• The power cord is unplugged for a long

time.

• The sound system you are trying to

record is DTS Surround.

• No batteries are inserted in the remote

controller.

• The batteries are worn out.
• The remote controller is not pointed at the

remote sensor of the DVD Changer
Receiver.

• The remote controller is too far from the

DVD Changer Receiver.

• Any wrong MODE button is pressed.

Remedies

• Switch the frequency receiving mode to

mono.

• Adjust the position, height, and direction

of the FM antenna.

• Connect an FM outdoor antenna. Try to

use an antenna with more elements.
(For installation of the outdoor antenna,
consult your nearest dealer as it requires
special skills and experience.)


• The preset data in memory is lost. Preset

the radio stations again.

• DTS Surround sound is unable to be

recorded.

• Insert new batteries.

• Replace with new batteries.
• Point the remote controller at the remote

sensor of the DVD Changer Receiver.

• Operate the remote controller within 16

feet (5 m).

• Press the appropriate MODE button.

Pages

52

20, 21

20, 21


52

22

22
22

22

22

T

uner

Remote contr

oller

Recor

ding

Symptoms

Too much noise is heard or
sound is interrupted
occasionally. (The ST
indicator does not light
steadily.)

Sound is distorted or sound
volume decreases.

Sound is excessively
distorted.

No preset channels are
selected.

Sound is reproduced from
the speakers but not
recorded.

The buttons on the DVD
Changer Receiver operate
but the buttons on the
remote controller do not
operate.