Onkyo DR-C500 - Manual (Page 62)

62
1
2
3
1
2
DVD RCVR / VCR T V CBL / SAT
MODE
-- / ---
SEND / LEARN
TOP MENU MENU
RETURN ON SCREEN
CH CH VOLUME UP
DOWN
TV / VCR
S TA ND BY / O N
EN TER
LIGHT
DVD RCVR / VCR T V CBL / SAT
INPUT
DIMMER SLEEP
MASTER
VOLUME
PRESET
1 2 3
4 5 6
7 8 9
MEM CLR 0
R EP EA T
A-B RANDOM
MU TIN G
ENTER
PLAY PLAY
SP A SP B FM MODE SURROUND
SP SETUP IPM ACOUSTIC CONTROL LATE NIGHT
AUDIO ANGLE SUBTITLE ZOOM
SW MODE T.TONE CH SEL DISTANCE
PRGV DISC SLOW STEP
RC- 504 M
MODE
– +
ENTER
SEND/LEARN
indicator
MODE buttons
DVD RCVR / VCR T V CBL / SAT
MODE
ENTER
ENTER
Controlling other components connected to
the DVD Changer Receiver
Erasing all the commands
programmed under a MODE button
Press and hold down the desired
MODE button, press the ENTER
button twice, and then release both
buttons.
When you press the MODE button, the
SEND/LEARN indicator lights. When you
press the ENTER button, the lamp turns off.
When you release the buttons, the lamp
lights again.
Press and release the same MODE
button again.
When you release the button, the SEND/
LEARN indicator flashes twice slowly.
This erases all the commands
memorized to the MODE button.
Notes
• If no button is pressed for more than 30 seconds during the
erasing procedure, the remote controller exits the erasing mode.
Resume from Step 1.
• If you perform an invalid operation during erasing, the SEND/
LEARN indicator flashes three times quickly, and the remote
controller exits the erasing mode. Resume from Step 1.
• If many commands have been programmed to the MODE button,
then the SEND/LEARN indicator may remain lit for up to 20
seconds during Step 2. This is not a malfunction.
Erasing the programmed command
from one button
You can only erase memorized commands and not preset ones.
Press and hold down the desired
MODE button for the command,
press the ENTER button, and then
release both buttons.
When you press the MODE button, the
SEND/LEARN indicator lights. When you
press the ENTER button, the lamp turns
off. When you release the buttons, the
lamp lights again.
Press and release the button for the
command you wish to erase.
When you press the button, the SEND/
LEARN indicator turns off. When you
release the button, the lamp lights
again.
Press and release the same button
again.
The SEND/LEARN indicator flashes twice
slowly. The memorized command is
erased.
Note
• If no button is pressed for more than 30 seconds during the
erasing procedure, the remote controller exits the erasing mode.
Resume from Step 1.