Onkyo DR-C500 - Manual (Page 52)

52
-- / ---
SEND / LEARN
TOP MENU MENU
RETURN ON SCREEN
CH CH VOLUME UP
DOWN
TV / VCR
S TA ND BY / O N
EN TER
LIGHT
DVD RCVR / VCR T V CBL / SAT
INPUT
DIMMER SLEEP
MASTER
VOLUME
PRESET
1 2 3
4 5 6
7 8 9
MEM CLR 0
R EP EA T
A-B RANDOM
MU TIN G
ENTER
PLAY PLAY
SP A SP B FM MODE SURROUND
SP SETUP IPM ACOUSTIC CONTROL LATE NIGHT
AUDIO ANGLE SUBTITLE ZOOM
SW MODE T.TONE CH SEL DISTANCE
PRGV DISC SLOW STEP
RC- 504 M
MODE
– +
1
2
1
2
Listening to the Radio
3
There are two ways to select radio stations:
• Tuning manually
• Presetting radio stations then
selecting the preset stations
Note
• 10 AM and FM stations have already been preset. You can change
these according to your preference.
Presetting Radio Stations
You can preset up to 30 stations.
Unit
4
Tuning in a weak frequency (only for FM stations)
When you tune in a stereo FM station, the ST indicator lights up if
the signal is sufficiently strong.
If the signal is weak, you may not be able to tune to the station.
In this case, press FM MODE. The ST indicator and AUTO indicator
goes off. Then select the station to which you want to listen.
(At this time, the station will be monaural and interstation noise will
be heard.)
Tuning Manually
Tune in the radio station you wish
to preset (see steps in the left
column of this page).
Press PRESET MEMORY.
The MEM. indicator lights and the preset
number starts flashing in the display.
While the MEM. indicator is lit (for
about 8 seconds), press TUNING/
PRESET
4/¢ to select the
preset number.
Press PRESET MEMORY.
The radio station is registered to the
preset channel.
To register another preset station,
repeat steps 1 to 4.
Unit only
Remote Controller
Only
FM MODE
PRGV
Press INPUT 2/3 repeatedly to
select the band (FM or AM).
e.g. When FM is selected.
Note
• You can also select the band with the
remote controller. See next page.
Press and hold TUNING/PRESET
4/¢ for about 0.5 seconds.
Auto tuning starts. The tuner frequency
changes 0.1 MHz for FM and 10 kHz for
AM.
When a broadcast is received, scanning
stops and the frequency flashes in the
display.
• Manual tuning
The frequency changes until the
TUNING/PRESET
4/¢ is pressed
repeatedly.
While the frequency is flashing (for
about 5 seconds), press TUNING/
PRESET
4/¢ to change the
frequency.
• The frequency changes each time you
press TUNING/PRESET 4/¢.
• You can change the frequency as long
as the frequency in the display is
flashing. Each press of either button
causes the frequency to flash for about
5 seconds.
Before operating the
remote controller
Press MODE RCVR/VCR.
RCVR / VCR
3
Unit only
Appears when a broadcast is received.