Onkyo DR-C500 - Manual (Page 24)

24 24
→
Selecting the Subwoofer mode
Remote controller
Press SW MODE on the remote
controller.
With the first press of the button, you can
check the present setting. Then each
press of the button changes the subwoofer
mode as follows (a tip on how to select the
right subwoofer mode is in parentheses):
SW MODE 1
(When small–with limited bass signal
handling–front speakers are
connected)
↓
SW MODE 2
(When large–wideband–front speakers
are connected)
↓
SW MODE 3
(When large–wideband speakers are
connected to all channel)
↓
SW Off
(When no subwoofer is connected)
The initial setting is SW MODE 1.
SW MODE
SW indicator lights up when SW Mode 1, SW
Mode 2 or SW Mode 3 is selected.
Speaker Setup
You need to set up the speaker configuration for the speaker
system connected to the FRONT SPEAKERS A connectors.
Notes
• Speaker setup cannot be done if;
– Headphones are connected, or
– The FRONT SPEAKERS B system is On (see page 31).
• It is not necessary to set the parameters again once you have
completed the setup unless you change the speaker configuration.
→
1
2
Selecting the number of speaker
channels
-- / ---
SEND / LEARN
TOP MENU MENU
RETURN ON SCREEN
CH CH VOLUME UP
DOWN
TV / VCR
S TA ND BY / O N
EN TER
LIGHT
DVD RCVR / VCR T V CBL / SAT
INPUT
DIMMER SLEEP
MASTER
VOLUME
PRESET
1 2 3
4 5 6
7 8 9
MEM CLR 0
R EP EA T
A-B RANDOM
MU TIN G
ENTER
PLAY PLAY
SP A SP B FM MODE SURROUND
SP SETUP IPM ACOUSTIC CONTROL LATE NIGHT
AUDIO ANGLE SUBTITLE ZOOM
SW MODE T.TONE CH SEL DISTANCE
PRGV DISC SLOW STEP
RC- 504 M
MODE
– +
SP SETUP
SP A
SW MODE
Before operating the
remote controller
Press MODE RCVR/VCR.
Remote
controller only
SP SETUP
Speaker configuration indicators indicate
current speaker configuration.
SLOW
SP A
RCVR / VCR
The remote controller
remains in the RCVR/VCR
mode, until another MODE
button is pressed.
The normal display resumes in three
seconds.
Speaker configuration indicator in the
lower right corner shows the current
speaker configuration.
Note
• To check the present setting while the normal display is
displayed, press SP SETUP once. To change the setting, press
the button repeatedly within three seconds.
Speaker Position: Indicates the position of a
selected channel.
Input format: Lights when a signal is input
for that channel.
Output format: Lights when a signal is
output for that channel.
Pressing the button repeatedly within three
seconds changes the number of channels
as follows (the corresponding speaker
configuration is described in parentheses):
Speaker 5 ch
(Front left, center, and right,
plus surround left and right
speakers)
↓
Speaker 2 ch
(Front left and right speakers)
↓
Speaker 3 ch
(Front left, center, and right
speakers)
↓
Speaker 4 ch
(Front left and right, plus
surround left and right speakers)
Press SP A to select “SP A.”
Note
The unit must be set to “SP A” for the following
operations.
Press SP SETUP repeatedly to
select the number of channels for
the Speaker A system.
Speaker Position
Input format
Output format