One for All URC8820N - Manual (Page 9)

9
2. Enter 9 9 3 and then press any mode key once (e.g., TV). The
LED will blink twice.
3. Now, when you press VOL +, VOL -, or MUTE, the volume of
the selected device (e.g., TV) will be controlled regardless of the
mode you have selected.
Unlocking Volume Control For A Single Device
(Individual Volume Unlock)
1. After performing Global Volume Lock (see above), press a
desired mode key where you want volume to be unlocked (e.g.,
AUD) and controlled within its own mode.
2. Press and hold SET until the LED (red light) blinks twice, then
release SET.
3. Enter 9 9 3 and then press VOL - once. The LED will blink four
times.
4. If desired, repeat steps 1 through 3 (of this section) for each
device that you want volume to be unlocked.
5. Now, after you select a device that has volume unlocked (e.g.,
AUD), pressing VOL +, VOL -, or MUTE, will control the device’s
volume only in its own mode.
Unlocking All Volume Control
(Restoring Default Setting)
NOTE: Performing these instructions will restore independent
volume control for all programmed devices (e.g., TV volume control
in TV mode, VCR volume in VCR mode, etc.).
1. On the remote control, press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 3 and then press VOL + once. The LED will blink four
times.
3. Volume will again be independently controlled according to its
default states for all programmed devices.
Using Macros
You can program the M1 and M2 keys on your remote to perform
repetitive, time-consuming operations for easy, convenient access
through the press of a single key.
Macro keys are ideal for home theater operations, setting a favorite
channel, guide steps, or other multiple functions you would like to
control with one key press. Moreover, each macro key can hold up
to a total of 20 key presses.
NOTE: Programming a new macro over an existing one will erase
the original macro.
Programming A Favorite Channel
With so many channels available through your cable or satellite
system provider, you can program a macro that directly selects a
favorite channel with one key press.
For example, let’s assume your favorite cable programs are on
channel 52. Use the following instructions to program a macro key
for direct access of this channel:
NOTE: This example assumes the TV is tuned to the correct Input to
view your cable box.
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.