One for All URC8820N - Manual (Page 6)

6
CBL/SAT Code:
Brand Name:____________________
DVD Code:
Brand Name:____________________
PVR Code:
Brand Name:____________________
AUX Code:
Brand Name:____________________
Aux. Device Type:_______________
Programming Combo Device Control
You can set this remote to control your combo devices such as TV/
VCR, TV/DVD, Satellite/PVR/DVR, Home-Theater-In-A-Box, and many
others with a single code. For a complete list of combo devices,
refer to the “Device Table.”
NOTE: Some combo device types have codes that you can program
on separate device keys. For example, you can program DVD Player/
VCR Combo codes under the VCR or DVD mode keys. See the DVD/
VCR Combos section of the code lists; note that there are two
sections under this device type.
To control a TV/DVD Combo:
1. Turn on the TV/DVD Combo and insert a DVD.
NOTE: Please read steps 2 through 4 completely before
proceeding. Highlight or write down the codes and device you
wish to program before starting step 2.
2. On the remote control, press TV.
3. Press and hold SET until the LED (red light) blinks twice, and
then release SET.
4. Use the setup codes under the TV/DVD Combos heading (use
codes listed as “Controlled by TV key”). Locate the brand name
and then enter the first four-digit code for your device. If
performed correctly, the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4
and enter the same code again.
5. Aim the remote control at the device and press POWER once.
It should turn off. If the device does not respond, repeat steps
2 through 4, trying each code for your brand until you find
one that works. If it still does not work, try “Searching for Your
Code”.
Searching For Your Code
If your device does not respond to the remote control after trying
all codes listed for your brand, or if your brand is not listed at all,
try searching for your code. For example, to search for a code for
your TV:
1. Turn on your TV and on the remote control, press TV once.
2. Press and hold SET until the LED (red light) blinks twice, then
release SET.
3. Enter 9 9 1. The LED will blink twice.
4. Select a test function from the list below or use the default test
function (POWER) and skip step 4.
NOTE: The keys that can be used for the test function are 0, 1,
2, 3, POWER, VOL +, Play, Stop and MUTE.