One for All URC8820N - Manual (Page 3)

3
Key Charts
The LED (red light), which is located
underneath the POWER Key, blinks
to show that the remote control is
working and is sending signals.
Press TV, CBL/SAT, VCR, DVD, CD,
PVR, AUD, or AUX once to select a
desired home entertainment device
to control.
Press POWER once to turn on or
off the selected device. For master
power control, see “Programming a
Master Power Macro.”
Press MENU once to display your
selected device’s main menu.
Use GUIDE to display your selected
device’s program guide or setup
menu.
Use EXIT to exit from your selected
device’s guide or menu.
Use INFO to display the current
channel and program information.
Use the Cursor Keys to move the
cursor in the program guide and
menu screens.
Use OK to choose options from your
selected device’s menu or guide.
In the RCVR/AMP mode, use OK to
set the surround sound. Use the up
arrow (or down arrow ) to adjust
the volume higher (or lower).Use
the left arrow (or right arrow) to
adjust the balance left (or right).
Use VOL + (or VOL -) to raise (or
lower) the sound volume.
Press MUTE once to turn the sound
off or on.
In TV, VCR, DVD, or CBL/SAT modes, use FAV to scan favorite
channels and/or all channels. (See “Using Channel Scan” and
“Programming Favorite Channel Scan.”)
Use CH + (or CH -) to select the next higher (or lower) channel.
Press PREV once to recall the last-viewed channel and to page back
one screen on the main menu. In the AUD, DVD and CD modes, use
DISC to change disk (if available on your device).
Use the keypad (1 ~ 9 and 0) to directly select channels (e.g., 009 or
031). In the AUD mode, use the keypad (1 ~ 9 and 0) to select audio
sources 1 through 10.
Press ENTER once after entering the channel numbers on some TVs.
In the CD mode, use ENTER to add 10 to the digit entry (e.g.,
ENTER and 7 is 17).