One for All URC8820N - Manual (Page 13)

13
Using Keymover
This remote includes a Keymover feature that allows you to map (or
copy) keys from one mode (i.e., source mode) to another mode (i.e.,
destination mode).
NOTE: The following keys cannot be used as a source or
destination: TV, CBL/SAT, VCR, DVD, CD, PVR, AUD, AUX, FAV,
and SET.
Programming Keymover
For example, if your VCR does not have volume control, you can
map those keys (i.e., VOL +, VOL -, and MUTE) from the TV mode
to the VCR mode as follows:
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
2. Enter 9 9 4. The LED will blink twice.
3. For the source mode, press TV once.
4. For the source key, press VOL + once.
5. For the destination mode, press VCR once.
6. For the destination key, press VOL + once.
7. The LED will blink twice, indicating the keymoved sequence is
correct.
8. Repeat steps 1 through 7 twice more to map remaining volume
control keys, substituting VOL - and MUTE as source and
destination keys in steps 4 and 6.
Upon completion of the above procedure, you can now use this
remote to control the TV’s volume and MUTE in the VCR mode, as
well as in the TV mode.
Restoring Keymoved Keys To Default Settings
Restoring a Single Keymoved Key
1. Press a device key that has a keymoved key.
2. Press and hold SET until the LED (red light) blinks twice, then
release SET.
3. Enter 9 9 4. The LED will blink twice.
4. Press the destination key twice (where the keymoved key is
stored). The LED will blink twice.
Restoring All Keymoved Keys in a Single Mode
1. Press and hold SET until the LED (red light) blinks twice.
2. Enter 9 9 4. The LED will blink twice.
3. Press the destination mode twice (where keymoved keys are
stored). The LED will blink twice.
Restoring Factory Default Settings
This remote includes a Setup Code Reset program. You can use it to
restore all your programmed codes to factory settings and delete all
custom programming.
IMPORTANT: Executing this program erases all code settings and all
custom settings including, Macros, Learned Keys, Reassigned Device
Keys, Keymoved Keys, Favorite Channels, and all device settings.
1. On the remote control, press and hold SET until the LED (red
light) blinks twice.
2. Enter 9 8 0. The LED will blink four times.
3. Your remote is now ready for programming.