One for All URC8820N - Manual (Page 5)

5
DEVICE
KEY
CONTROLS THESE DEVICES
CD
CD, Home Automation, CD/R (Recorders)
PVR
PVR/DVR Only Devices
AUD
Tuner, Amp, Misc. Audio, HTiB (Home
Theater In A Box)
AUX
Tuner, Amp, Misc. Audio, HTiB (Home
Theater In A Box)
Setting Up Your Components
This remote is preprogrammed at the factory to operate a Sony
TV, DVD and VCR, an RCA DirecTV Satellite box, a Sony Tivo PVR, a
Pioneer Receiver and CD, and a Sony Receiver (in the AUX Mode).
To control devices other than the default brands, perform the
following steps; otherwise skip this section.
NOTE: For Combo Device control, see the next section.
1. Turn on a device (e.g., TV, VCR or DVD player) and, if applicable,
insert media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before
proceeding. Highlight or write down the codes and device you
wish to program before starting step 2.
2. On the remote control, press a device key once (i.e., TV,
CBL/SAT, VCR, DVD, CD, PVR, AUD, or AUX).
3. Press and hold SET until the LED (red light) blinks twice, then
release SET.
4. Use the accompanying code lists to locate the type of device
and brand name and then enter the first four-digit code for
your device. If performed correctly, the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4
and enter the same code again.
5. Aim the remote control at the device and press POWER once.
The device should turn off. If it does not, repeat steps 2 through
5, trying each code for your brand until you find one that
works. If it still doesn’t work, try “Searching for Your Code.”
NOTE: If the device does not have a POWER key, press the
(PLAY) key.
6. Repeat steps 1 through 5 for each device you want to control.
For future reference, write down each working device code in
the following boxes:
TV Code:
Brand Name:____________________
VCR Code:
Brand Name:____________________
CD Code:
Brand Name:____________________
AUD Code:
Brand Name:____________________