One for All URC8820N - Manual (Page 2)

2
Introduction
The One For All 8-Device Universal Remote Control with Learning
(URC-8820N) is pre-programmed with the latest library of codes,
and it is designed to operate up to eight home entertainment
devices, including TV, video, DVD, Cable, Satellite and audio
components. The remote control requires two (2) new AAA alkaline
batteries (not included) and easy programming to control your
devices. For best results, please read and perform all instructions
listed here. Also, keep these instructions for future reference.
Installing Batteries
1. On the remote control’s back, push down on the top of the
battery cover (where indicated by the arrows). Then slide the
battery cover out.
2. Obtain two (2) new AAA
alkaline batteries. Match the
+ and – marks on the batteries
to the + and – marks in the
battery case, then insert the
new batteries.
3. Slide the battery cover back
into place. The tab should click
when the cover is locked.
4. Test the remote control by
first pressing POWER and then
any mode key (e.g., TV). If the
batteries are inserted correctly,
the LED (red light) will blink
once.
NOTE: When batteries are low,
the remote control will blink
5 times after each key press.
The remote will stop operating
when the batteries need
replacement. The permanent
memory retention ensures
that your codes are stored
permanently even during
battery replacement.
Battery Precautions:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
• Always remove old, weak or worn-out batteries promptly and
recycle or dispose of them in accordance with Local and National
Regulations.
Features and Functions
Use the Key Charts to learn how to use the universal features and
functions of this remote.