Using the listening modes —continued, 1 channel sources (3/3) – Onkyo TX-NR1007 User Manual

Page 82

5.1 channel Sources (3/3)

✔: Available Listening Modes

Notes:

*1 For 7ch output, output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the

*2 For 9ch output, output can be switched between the combination of Surround back and Front high, or Surround back and Front wide

speakers by pressing the [SP LAYOUT] button.

*3 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better sound

according to the player. In that case, set the output setting on the player side to PCM.

*4 This listening mode can be selected only when all the following conditions are satisfied:

a. Center speaker is connected to the AV receiver.
b. Either of Front High speakers or Front Wide speakers is connected to the AV receiver.

*5 This listening mode is not available while you are using Zone 2 (“Not Available” will appear on the display). If you turn Zone 2 on during

the Pure Audio listening mode, the listening mode will change to Direct.

*6 Depending on the input source, DTS is used.

• Available sampling rate for PCM input signal is 32/44.1/48/88.2/96/176.4/192kHz.
• The listening modes cannot be selected with some source formats.

Listening Mode

Button

Speaker layout

T-D (Theater-
Dimensional)

✔

DTS Surround
Sensation

✔

SBR

SBL

SBR

SBL

SBR

SBL

SBR

SBL