beautypg.com

Selecting speaker layout, Using headphones, Selecting speaker layout using headphones – Onkyo TX-NR1007 User Manual

Page 65: Basic operations —continued

background image

65

Basic Operations

—Continued

You can select the priority of the use of Front High
speakers or Front Wide speakers.

Notes:
• If the Powered Zone 2 is being used (page 127), this

setting cannot be selected.

• When the listening mode that doesn’t support Front

High or Front Wide speakers is used, the setting can-
not be selected.

• If you use surround back speakers, the speaker selec-

tion will be based on the combination of surround
back and front high speakers, or surround back and
front wide speakers.

You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV receiver’s PHONES jack for pri-
vate listening, as shown.

Notes:
• Always turn down the volume before connecting your

headphones.

• While the headphones plug is inserted in the PHONES

jack, the Headphone indicator, speaker/channel indi-
cator FL and FR light up. (The Powered Zone 2/3
speakers are not turned off.)

• When you connect a pair of headphones, the listening

mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, Pure Audio or DTS Surround Sensa-
tion.

• Listening mode automatically changes into DTS sur-

round sensation when you connect a pair of head-
phones while DTS surround sensation mode is
currently selected.

• The following listening modes can be used with head-

phones (the listening modes available also depend on
the currently selected input source): Stereo, Direct,
Pure Audio, Mono and DTS Surround Sensation.

Selecting Speaker Layout

Remote

controller

Press the [RECEIVER] button,
and then press the [SP LAYOUT]
button repeatedly to select:
FrontHigh or FrontWide.

FrontHigh:

The sound from front high speakers
is output by priority.

FrontWide:

The sound from front wide speakers
is output by priority.

Using Headphones