Olympus C-2/D-230 - Manual (Page 15)

15 En
En
3 When the current Macro mode display indicates [OFF], press the
button once again.
The Macro mode is set and the monitor turns on.
4 Take a picture by composing the subject using the monitor.
Note The Macro mode is canceled when the clear settings value is [RESET] and the
lens barrier is closed. See “Clear settings” (
p.27).
Caution
• When using the Macro mode, keep the distance between the camera and the
subject at a distance of more than 10 cm (4 in).
• If you try to take a picture at a distance of less than 10 cm (4 in), the autofocus
will not work properly even though the shutter button is pressed.
• In macro shooting, shadows may be conspicuous or correct exposure may not
be achieved. Always check the images on the monitor after macro shooting.
DIGITAL TELE MODE
This mode enables you to enlarge the image to magnifications 1.6 Ч, 2Ч,
2.5
Ч, 3.2Ч, 4Ч and 5×.
The image quality needs to be set to SQ2 to magnify 3.2
Ч, 4Ч or 5×. See
“Image quality” ( p. 20).
1 Open the lens barrier.
The camera turns on in the Record mode.
2 Press the button.
The monitor automatically turns on, and the image is displayed in size of 1.6 ×.
3 Press the / buttons looking at the monitor.
The image can be magnified in the sequence [1.6 Ч] → [2.0Ч] → [2.5Ч] →
[3.2
Ч] → [4.0Ч] → [5.0Ч] each time the
button is pressed, and the image
is zoomed out in the sequence [4.0 Ч] → [3.2Ч] → [2.5Ч] → [2.0Ч] → [1.6Ч] →
No display(1.0) each time the button is pressed.
4 Take a picture by looking at the monitor.
Note • Press the button to turn the monitor off and cancel the Digital tele mode.
• The image may be of a lower resolution and appear grainy when the Digital
tele mode is used.
• The Digital tele mode can not be used in the Movie mode.
EXPOSURE COMPENSATION
Although the camera’s exposure is set automatically, you can vary it to
change the image brightness in the range of ±2 stops in 0.5-stop steps.
Note • Use this function to obtain correct brightness (exposure) when there is
significant contrast (difference in brightness) in the image.
• Set a [+] value to make the image brighter and a [–] value to make it darker.
1 Open the lens barrier.
The camera turns on in the Record mode.
1/Basic04_C2-E.65E 8/22/01, 5:42 PM 15