Oracle Audio Technologies Sun Oracle SunDual 10GbE XFP User Manual
Page 69
Chapter 7
Configuring Link Aggregation
59
2. Plumb up the interface aggr
key, which is aggr33 is this case:
3. Show link-aggregation status again, and now the state should become attached:
4. Use the dladm show-aggr -s command to display statistics:
5. Use the dladm show-aggr -L command to display LACP specific
information:
For more information refer to the man pages for dladm, man dladm.
# ifconfig aggr33 plumb
# ifconfig aggr33
aggr33: flags=1000842
inet 0.0.0.0 netmask 0
ether 0:3:ba:d8:9d:e8
# ifconfig aggr33 192.168.1.1/24 broadcast + up
# ifconfig aggr33
aggr33: flags=1000843
inet 192.168.1.1 netmask ffffff00 broadcast 192.168.1.255
ether 0:3:ba:d8:9d:e8
# dladm show-aggr
key: 33 (0x0021) policy: L4 address: 0:3:ba:d8:9d:e8 (auto)
device address speed duplex link state
nxge0 0:3:ba:d8:9d:e8 10000 Mbps full up attached
nxge1 0:3:ba:d8:9d:e9 10000 Mbps full up attached
# dladm show-aggr -s
key: 33 ipackets rbytes opackets obytes %ipkts %opkts
Total 0 0 16 1182
nxge0 0 0 16 1182 - 100.0
nxge1 0 0 0 0 - 0.0
# dladm show-aggr -L
key: 33 (0x0021) policy: L4 address: 0:3:ba:d8:9d:e8 (auto)
LACP mode: off LACP timer: short
device activity timeout aggregatable sync coll dist defaulted expired
nxge0 passive short yes no no no no no
nxge1 passive short yes no no no no no