Olympus PT-E02 - Manual (Page 62)

E-21
En
(3) Place the camera table with the attached digital
camera on the camera table base in the Case.
Do not load the combination by force, but load it
gently so that the digital camera does not
interfere with parts inside the Case.
After loading the digital camera, connect the hot
shoe cable to the camera’s hot shoe.
Once the digital camera is fully inserted, turn
the lock lever on the camera table to lock it.
Gently push the Case’s mode dial down and confirm that the zoom dial can smoothly
control zooming, the power switch lever can turn the digital camera ON/OFF, and that
the mode dial can control the mode dial of the camera.
: • Read the Waterproof Port’s instruction manual carefully to ensure that you
correctly attach the zoom gear to the lens’s zoom ring before loading the
digital camera. Make sure the zoom ring is positioned correctly during loading.
• If the zoom gear on the lens is not engaged properly with the gear on
Case’s zoom dial, zooming cannot be controlled. Even when the gears are
meshed properly, the lens zooming range may be restricted by the way the
digital camera has been loaded. Read the Waterproof Port’s instruction
manual carefully and set the zoom gear appropriately.
• When the focusing gear is attached to the lens, also confirm the gear mesh
condition.
CAUTION