Oricom ECO600 - Manual (Page 7)

About your phone
7 7
Getting Started
CONNECTING YOUR PHONE
1. Connect the output plug of the mains
adaptor to the bottom of the base
unit.
2.
Connect the mains adaptor to a
standard wall outlet.
3. Connect the telephone line cord to
the phone sockets at the bottom of
the base unit and the wall phone
socket.
Note: In Australia some phone wall sockets
are the old “non modular” style. If you
have this type of wall socket you will need
to purchase a modular converter plug (not
supplied).These can be obtained from
electronic stores.
CHARGING YOUR HANDSET
1. Place the 2 rechargeable batteries
(supplied) into the battery
compartment.
2. Slide the battery door firmly into
place.
3. Place the handset on the base unit or
charger for charging.
IMPORTANT NOTE:
DO YOU HAVE BROADBAND? If you do you must connect an in-line filter (not
supplied) between the telephone socket and your ECO60 phone base to ensure that your broadband
and phone work properly.
Ensure all phone sockets in use have their own in-line filter.
WARNING: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. Never use non-rechargeable batteries. Use recommended type supplied
with this product. Ni-MH batteries must be disposed of in accordance with the
NOTE:
Charge the handset(s) for 14 hours before initial use!
NOTE:
Handset may get warm during initial charge. This is normal. The handset
may take a few seconds to power up.
CAUTION: Check the batteries polarity when inserting the batteries. Incorrect
polarity may damage the product.