Oricom ECO600 - Manual (Page 21)

The System
21 21
CHANGING THE SYSTEM PIN
The system PIN is used for registering, deleting handsets, and protecting the access rights to
some of the other menus. The pre-set system PIN is 0000. You can personalize the PIN for
greater security.
1. Press .
2. Select SYSTEM Æ CHANGE PIN . Press .
3. Enter the system PIN. Press to confirm. Use to make a correction.
4. Enter the new system PIN. Press .
5. Enter the new system PIN again for verification.
6. Press . The new setting is saved.
RESETTING TO FACTORY DEFAULT SETTINGS
You can reset your phone settings to the factory default.
1. Press .
2. Select
SYSTEM Æ RESET
. Press .
3. Enter the system PIN. Press to confirm all settings have reset.
FACTORY DEFAULT (PRE-PROGRAMMED) SETTINGS
General Setting
Language English Handset Name Reset
Auto Answer Off
Recall Duration Recall 1
Sounds Setting
Handset Melody Melody 1 Handset Ringer Volume Level 3
Handset Key Tones On Receiver Volume Level 2
Handset Tones On
Call Log Setting
Incoming Call Log Unchanged Dialed Call Log Unchanged
Message Waiting Indicator Reset
System Setting
Base Selection Auto PIN Code 0000
NOTE:
Forgotten PIN. Write down your PIN and save it for future use. If you
have forgotten the PIN, call your manufacturer for assistance.
NOTE:
After reset, your handset’s power switches off. It will switch back on in a
few seconds after updating all the settings.