Setup utilities for mac os 8.x and 9.x, Configuration, Appletalk configuration – Olivetti P26W User Manual
Page 85: Configuration appletalk configuration, Os 8
Apple Macintosh> 85
S
ETUP
UTILITIES
FOR
M
AC
OS 8.
X
AND
9.
X
Use the Network Card Setup Utility
(Macintosh) to assign an IP address and
configure the network interface card. For
instructions please refer to the
Configuration Utility section and on-line
help.
C
ONFIGURATION
There are three items that need to be configured for EtherTalk.
Use EtherTalk Protocol
Please check the Use EtherTalk Protocol checkbox.
1.
Printer Name
2.
Give the Printer Name as you would like it to appear in the
Chooser.
3.
Zone Name
If your network uses Zones, please enter the Zone Name
here, otherwise leave as is.
A
PPLE
T
ALK
C
ONFIGURATION
To enable network printing from the Macintosh, you must
configure AppleTalk to connect via Ethernet.
1.
From the Apple menu select [Control Panels – AppleTalk].
2.
From the AppleTalk configuration page select [Connect
via: Ethernet].
3.
In Setup Current Zone, if used, make sure that your zone
information is correct.
4.
Close the AppleTalk configuration page and save changes
to current configuration when prompted.
5.
Configuration is now complete and you are ready to install
your printer driver. Please enter your driver CD, run the
installer and follow the on-screen instructions.