Onkyo TX SR607 - Manual (Page 45)

45
First Time Setup
—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE IN/
OUT jacks, or connect an RI Dock to the GAME IN or
VCR/DVR IN jacks, for
to work properly, you must
change this setting.
This setting can only be changed on the AV receiver.
Notes:
• DOCK can be selected for the TV/TAPE or GAME or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before
using the AV receiver’s remote controller for the first
time (see page 91).
4 Use the Left and Right [ ]/[ ]
buttons to select:
(North American/Taiwan models)
200kHz/10kHz:
Select if 200 kHz/10 kHz steps are
used in your area.
50kHz/9kHz:
Select if 50 kHz/9 kHz steps are
used in your area.
(Asian models)
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
5 Press the [SETUP] button.
The setup menu closes.
Changing the Input Display
1 Press the [TV/TAPE], [GAME] or
[VCR/DVR] input selector button
so that “TV/TAPE”, “GAME” or
“VCR/DVR” appears on the
display.
2 Press and hold down the [TV/
TAPE], [GAME] or [VCR/DVR]
input selector button (about 3
seconds) to change the setting.
Repeat this step to select MD, CDR, or
DOCK.
For the TV/TAPE input selector, the
setting changes in this order:
For the GAME input selector, the
setting changes in this order:
GAME
↔
DOCK
For the VCR/DVR input selector, the
setting changes in this order:
VCR/DVR
↔
DOCK
GAME TV/TAPE
VCR/DVR
or or
or
or or
or
TV/TAPE
→
MD
→
CDR
DOCK
→
→